black and grey on one page

Technical support for APFill users
Post Reply
Posts: 2
Joined: 03 Jan 2014, 10:06

black and grey on one page

Post by michaeldoggett »

I have an A4 page, half is black and half is grayscale. Apfill tells me that the page is 100% black. How do I get it it to tell me the density of the greyscale area?
AVPSoft support
AVPSoft support
Posts: 326
Joined: 01 Nov 2004, 21:25

Re: black and grey on one page

Post by support »

I guess you use RGB coverage mode. To get a coverage with regard to intensity you should use the "Page Total Coverage" value instead of the "Common coverage ratio".

Here are details:
PAGE TOTAL COVERAGE DENSITY indicates page coverage considering intensity (RGB). This value corresponds to the 5% ink coverage value usually specified in printer manuals. The result can be presented as following: the whole page is converted to the black-and-white format and ink is evenly distributed on the page; get the page evenly filled with gray color of the specified intensity (from 0% to 100%).

IT IS EQUIVALENT TO (5% PAGES): displays the number of standard 5% pages to which your layout sheet is equivalent. That is, when "Page total coverage density" equals 10%, this means the printer will use the amount of ink/toner sufficient to print two pages with the standard 5% coverage density.


"COMMON COVERAGE RATIO": This is the percent of all pixels other than white in the selected area. Example: if the rate is 80%, this means that 80% of the page will be covered with ink and 20% will remain blank. Attention: this parameter does not take account of the pixel intensity, i.e. in this case only the coverage area is considered. That is why the COMMON COVERAGE RATIO is always greater than PAGE TOTAL COVERAGE DENSITY and will equal to it only if the whole area is filled with 100% color intensity.
Post Reply